To assemble an O-Cedar mop, loosely hold the handle vertically to allow the mop to spin, push the pedal to customize moisture level, and store the bucket in dry conditions.
The EasyWring Spin Mop does not require assembly and its microfiber mop head is smaller than other O-Cedar mops.
How do I adjust the height of the O-Cedar mop handle?
To adjust the height of the O-Cedar mop handle, turn it counterclockwise to lengthen it.
Once you have adjusted it to your desired height, turn it clockwise to lock it into place.
This may take up to two minutes.
Finally, screw the handle into the mop head.
Can I disassemble the EasyWring Spin Mop for easy storage?
The O-Cedar EasyWring Spin Mop & Bucket System has a telescoping handle that can collapse for easy storage.
It is unclear whether the mop can be disassembled for storage, but replacement handles can be purchased online.
What type of surfaces can the O-Cedar mop be used on?
The O-Cedar mop can be used on most hard flooring surfaces, including hardwood, tile, laminate, ceramic, marble or stone surfaces.
It is safe to use on all types of hard floor surfaces.
How often should I replace the microfiber mop head on my O-Cedar mop?
O-Cedar recommends replacing the microfiber mop head refill every 3 months.
Cotton mops should be replaced after 15 to 30 washings, which is approximately equivalent to 500 uses.
It is also recommended to replace the mop head frequently for best results.
Are there any specific cleaning solutions or detergents that should be used with the O-Cedar mop?
According to the O-Cedar website, all you need to clean with their microfiber mops is water.
However, there are many other cleaning solutions that can be used with the mop, such as vinegar, rubbing alcohol, and essential oils.
Mild dish soap is also a good option for most floor types.